Technics
Audio & Hifi
Maintenance & Repair
Cables
DJ Gear
Vinyl
0
Your Cart
Nagaoka JN-P500
Hover over an image to enlarge
Nagaoka JN-P500
Original replacement stylus for the Nagaoka MP-500 cartridge
The pure diamond (nude shank) needle tip has a so-called SuperFine line contact and is located at the end of a boron cantilever.
The recommended stylus pressure is approximately 1.30 - 1.50 grams while the frequency range is from 20 Hertz to 25 kiloHertz.
ALBEPRO is NAGAOKA's official dealer in the Netherlands
The complete "MP" program and the new "JewelTone" series from Nagaoka can be found in our program including the new DJ-44G replacement needle.
Nagaoka program
Specs
| Model | MP-500 |
| Type | Moving Permalloy |
| Frequency Response | 20-25.000 Hz |
| Vertical Tracking Angle | 30 ° |
| Vertical Tracking Force | 1.3 – 1.8 g |
| Recommended VTA (VTF) | 1.3 g |
| Stylus Construction | Naked diamond, square shrank |
| Stylus Shape | Superfine polished line-contact |
| Stylus Curvature Radius | 0.3 x 0.5 mil (about) |
| Recommended Load Impedance | Min. 47K ohms (when head amplifier is connected) |
| Recommended Load Capacitance | 100 pF |
| Coil Impedance | |
| DC Resistance | |
| Coil Inductance | |
| Output Voltage | 3.0 mV (at 1 kHz, 5 cm/sec) |
| Output Channel Balance | Better than 1.0 dB (1 kHz) |
| Channel Separation | Better than 27 dB (1 kHz) |
| Cantilever | Low-mass, high strength Boron cantilever ? mm diameter |
| Static Compliance | |
| Dynamic Compliance | 8.5 x 10-6 cm/dyne (100 Hz) |
| Mounting | Half-inch |
| Cartridge Weight | 7.8 g |
| Cartridge & headshell Weight | 26.1 g |
| Wire Used for Coil | High Purity Copper Wire （φ0.04 3UEW） |
| Body Material | Anti-ferro magnetic permalloy shield casing |
| aluminum | |
| Mounting Feature | Half-inch mount |
| Terminal Pins | Brass（gold plated） |
| Dimensions | 18.0 mm H × 17.0 mm W × 28.6 mm D |
| Accessories Included (cartridge only) | non-magnetic screwdriver & hex screwdriver |
| 2 washers & 2 nuts | |
| cartridge installation screws | |
| 10 mm × 2,8 mm × 2 | |
| 13 mm x 2,8 mm x 2 | |
| plastic protector | |
| Accessories Included (cartridge +Headshell) | hex screwdriver, plastic protector |
| Notes | Mounting Feature: |
| Note: |